This entry was posted on Sunday, May 9th, 2010 at 11:41 pm and is filed under Alfa Romeo. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
Site Search:
i have replaced the head gaskets that were bad and i still have water entering the oil. where is the next most likely place that it will be entering.
read comments (4)
May 10th, 2010 at 12:13 am
could be a cracked block or cracked head.
May 10th, 2010 at 12:38 am
The problem is from the cylinderhead. When you take of te cylinderheadpay 50euro and get it for a heat pressing. Then you will know if you need a new cylinderhead. If you the is no crack on the head, all you have to do is to replace the gasket… You did’nt mentioned if you have a boxer engine…
May 10th, 2010 at 1:16 am
Did you check to see if the heads were flat before you replaced the gaskets? What car and engine do you have? Other sources could be a crack in the block which would be bad, real bad. Good luck I hope it is just something simple.
May 10th, 2010 at 1:33 am
It seems that your cylinder liner has cracked. Your cylinder liner contains a water cooling jacket. You need an engine overhaul.