This entry was posted on Sunday, February 28th, 2010 at 11:47 pm and is filed under Jeep. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
Site Search:
February 28, 2010
- Use with the No. 7249 ball joint set to remove or install aftermarket and original equipment upper and lower ball joints
- Removes and installs the offset ball joints used to change caster/camber
- Use with the 7249 ball joint set
Product Description
This ball joint adapter set Works on 1984-newer “downsized” Jeep Wagoneer, and 2WD and 4WD Cherokee and Comanche; 1987-newer Jeep Wrangler; 1990-newer Jeep Renegade; 1993-newer Jeep Grand Cherokee; 1994-newer Dodge Ram 1/2-ton 4WD pickup. Use with the 7249 ball joint set to remove or install aftermarket and original equipment, upper and lower ball joints, and the offset ball joints used to change caster/ camber…. More >>
OTC 7894 Dodge Ram / Jeep 4 WD Ball Joint Adapter Set
read comments (1)
March 1st, 2010 at 1:29 am
Adapters work well with the OTC 7249 ball joint service tool set that I bought at the same time. Installer receiver piece is the correct configuration to allow the ball joints to be pressed in squarely to the angled Dana 30 yoke without damaging the yoke bores. Installer cup is a bit too large to fit snugly on Moog K3134T Upper and K3161T Lower ball joints and has a tendency to slip off edge if you’re not careful – the only reason I didn’t rate 5 stars. Not sure why the adapter set costs more than the 7249 ball joint press tool set, but no other way to install Jeep ball joints properly, so I wouldn’t recommend trying this job without these adapters.
Rating: 4 / 5